The better solution is to install additional speakers in the center between the other height channels (Top Middle position). Those speakers are now fixed in place with wiring through the walls and ceiling, and I can’t move them without remodeling the room. This issue is compounded by the fact that the locations where I had installed speakers when I built the home theater (before immersive audio was a concern I gave any thought to) were less than ideal for Atmos. That, combined with a low ceiling, makes it difficult for just four speakers (two in the front of the room and two in the back) to image a sound above my head convincingly. My own home theater is a long room with a lot of space behind my seats.

You also might try to remove a memory module as well.Nonetheless, for some of us, a limit of four height channels isn’t enough to fill the top of the room with sound. If your PSU is modular, check both ends.įinally, as a last resort, try moving the video card to the x4 slot on the motherboard. If you haven't done so, unplug and re-plug all the motherboard power connectors (including both motherboard power connectors, 24 pin and 8 pin) and video card power connectors. If it still doesn't work, since it isn't working with another known-good video card, do you have a way to test the monitor independently just to ensure that it is itself working? It might not be a bad idea to swap the video card cable, and also to plug the monitor in to a different video output if you have one available? After you reset the CMOS and re-power the system, let it sit for a while (especially if your DRAM is not on the motherboad QVL list).

Now, that said, I've read accounts of this particular motherboard spending an inordinate amount of time memory training (sometimes 30 to 60 minutes).

Do not leave the jumper there! Location is shown below. There is a jumper on the motherboard - just turn off the power, put a jumper across the pins, remove the jumper, and re-apply the power.

Afterburner oc scanner